武汉旭之昂汽车零部件有限公司
imgboxbg

How can we improve the efficiency of machining machinery parts?

  • Categories:Industry
  • Author:
  • Origin:
  • Time of issue:2019-09-12 16:30
  • Views:

(Summary description)First of all, machine parts should be machined with high cutting speed. When machining machine parts, we should select machines with good quality, good dynamic characteristics and low rotational vibra

How can we improve the efficiency of machining machinery parts?

(Summary description)First of all, machine parts should be machined with high cutting speed. When machining machine parts, we should select machines with good quality, good dynamic characteristics and low rotational vibra

  • Categories:Industry
  • Author:
  • Origin:
  • Time of issue:2019-09-12 16:30
  • Views:
Information

First of all, machine parts should be machined with high cutting speed. When machining machine parts, we should select machines with good quality, good dynamic characteristics and low rotational vibration, which can improve the cutting speed and cutting stability of the machine. Processing efficiency of precision mechanical parts. The cutting speed selected by the non-standard equipment parts processing internship is often selected according to the dynamic characteristics of the ultra-precision machine tool used and the dynamic characteristics of the cutting system, that is, the vibration speed is selected. Due to the low surface roughness and the quality of mechanical parts processing at this speed. Obtaining high-quality non-standard mechanical parts processing appearance is the primary question of non-standard equipment parts processing. The use of good quality, especially the ultra-precision machine with good dynamic characteristics and small vibration can use high cutting speed, which can improve the processing power of mechanical parts.

The selection of machining parameters for non-standard equipment parts mainly includes the selection of the viewpoint of the cutting tool, the selection of the cutting speed, and the selection of the cutting depth and the feed rate. From the past experience, we know that when processing plastic data, if you choose a tool with a large front angle, you can use the structure of hoarding. This is when the tool rake angle increases, the cutting force is reduced, the cutting deformation is small, and the cutter and chip are small. The contact length is shortened, which reduces the basis of the built-up structure.

Scan the QR code to read on your phone

  • tb
  • tb
  • tb
  • tb
  • tb
  • tb

Copyright (C) 2019 xzaparts.com All Rights Reserved      ICP:19020641-1         Power by www.300.cn